It's that easy ...

1. Preparation: Remove any loose, projecting parts. The area to be repaired must be clean, dry and free from grease. HINT: Clean surface with alcohol or thinner. Remove discolouration at edges with sandpaper or a (tooth) brush.
2. Filling: Remove the black cap from the Ceramic Filler. Attach the cannula firmly to the syringe. Apply the filler directly into the damaged area until area is slightly overfilled.
3. Curing preparation: Place the clear film strip directly onto the filled area. Use the wooden spatula to flatten the filling material. Make sure no bubbles will develop under the film.
4. Curing: Activate the Mini LED Light either by pressing the centre of the lamp or by moving the small slide regulator. Cure the filled area by illuminating for approx. 5-10 minutes per cm² from a distance of not more than 1 cm. Curing time varies dependent on coat thickness. NOtE: If the filler no longer hardens, please replace the UV lamp battery.
5. Remove the film: When filler has cured, remove the clear film strip.
6. Levelling: Use the Special Sandpaper to sand off excess material in a circular motion with light pressure until level. NOtE: Ensure not to sand through the filling!
7. Polishing: Remove the cap from the polishing paste and attach the cannula firmly to the syringe. Apply a small amount of polishing paste to the repaired area and rub in with the cotton cloth in a circular motion using light pressure until the sheen matches the surrounding area.
8. Cleaning: Clean away any polish residue with a dry and clean part of the cotton cloth. Done! IMpORtaNt: With damage of more than 1-1,5mm depth, it is necessary to work with several layers. Prefill and harden the damaged area (please see steps 2-4) and repeat process.

Safety Instructions for Mini LED Light: Do not look directly into the light, as this may lead to permanent eye damage. Keep out of reach of children.